Enlarge  

FingerTech Twist Hubs (pair)

Price: 16.22 CAD
12.36 USD 10.42 EUR

• Foam wheels are the preferred choice for combat robots because they absorb impacts and save your drive motors from stripping teeth.

• Use Twist Hubs to mount our FingerTech Foam Wheels, or if you already have Lite Flites (or their thinner counterpart Lectra Lites) they can be used with Twist Hubs too!

• With Twist Hubs, you can easily and securely mount these foam tires to your robot.

• The foam tire is held tightly by a custom locking washer, which must be pressed in and turned 90 degrees to release.

• The hub is secured to the motor shaft by a strong 8-32 setscrew.

• Available with 3mm and 4mm shaft bore, but can be drilled out as big as 6.35mm (0.25in).

• Make sure to choose the correct Thin/Wide size to match your wheels.


Bore
3mm (0)
4mm (0)
Width
0.50in (thin) (0)
0.75in (wide) (0)
Quantity
-
+
  • Description
  • CAD Files
  • Reviews
- Foam wheels are the preferred choice for combat robots because they absorb impacts and save your drive motors from stripping teeth.
- Use Twist Hubs to mount our FingerTech Foam Wheels, or if you already have Lite Flites (or their thinner counterpart Lectra Lites) they can be used with Twist Hubs too!
- With Twist Hubs, you can easily and securely mount these foam tires to your robot.
- Available in two widths; 0.50" (thin) and 0.75" (wide), and in two bore sizes; 3mm and 4mm.



Specifications:
- Anodized 6061 aluminum for high strength and low weight.
- The foam tire is held tightly by a custom locking washer, which must be pressed in and turned 90 degrees to release.
- The hex flange will allow you to keep driving even if the locking washer is destroyed.
- The hub is secured to the motor shaft by a strong 8-32 setscrew.
- Available with 3mm and 4mm shaft bore, but can be drilled out as big as 6.35mm (0.25in).
- Weight: Thin size (0.50in wide) weighs 5.5g each. Wide size (0.75in wide) weighs 6.7g each. (Remember that you will be removing the 3g plastic hubs from Lite Flites and Lectra Lites first!)



 Requires:
- 5/64" hex wrench
- Foam wheels (FingerTech Foam Wheels, Lite Flites or Lectra Lites)
- FingerTech Twist Hub Key or needle nosed pliers 
 
2 Product Reviews - Average rating 5 / 5 (Show All)

Click to review this product

Could go all three rounds with Muhammed Ali

- 19th February 2020

These hubs take massive hits. I've used them for two competitions now, and at Moto 2020 they took hits from a horizontal spinner, and stayed on after getting bent in half. It was actually difficult to get them off after they got hit. The wheels never budged. Great product! Thank you!

very secure

- 13th October 2019

These hubs work much better than the snap hubs, thank you Finger Tech for redesigning the hubs!

Click to review this product


Shopping cart  Shopping cart
0 Product(s) in cart
Total 0.00 CAD
» Checkout
Login Status  Login Status

Not logged in

» Login

credit cards